01
Removal of Slag and Brick from Ladles
Occasionally, a ladle will be red-hot during the slag removal process. As such, the job must be completed in both a safe and timely manner. One must act with caution when removing slag from ladles or risk damaging it, making precise and powerful tools a necessity.
Brokk demolition robots allow operators to move freely around the machine, allowing them to get the best angle of sight without compromising personal safety. Using a remote control, operators can avoid vibrations, gasses, and the risk of fire from the safety of a shielded cabin. Brokk’s three-part arm system is well suited for challenging operations due to their ability to work horizontally and reach nearly every angle within the ladle.
When a ladle is not too hot, bricks can be removed from the inside. At this time, the main concern is to avoid damaging the ladle shell and safety refractory linings, as well as maintaining the safety of workers from falling debris and saving time.




| Robot model used | Brokk 500 Machine weight: 5,9 tons Height: 1.8 m Travelling width: 1,6 m Length: 4,5 m Arm extension: up to 7,3 m |
|---|---|
| Ladle internal diameter | Approximately 3 m |
| Performances | Time measured from positioning of machine to end of cleaning Ladle 1 → 7 min · Ladle 2 → 5 min · Ladle 3 → 3 min · Ladle 4 → 3 min Ladle 5 → 2 min · Ladle 6 → 2 min · Ladle 7 → 4 min · Ladle 8 → 5 min Average of 8 ladles: 3,88 minutes |
| Other results | Removal of slags with hydraulic hammer during production with ladles red hot. Removal to high grade of cleanliness. |
Tab. 1 – Remote demolition robot performances during removal of slags from red hot ladles, in production line. Feralpi steel plant, Lonato del Garda, Italy.















